3D Printed Musical Instrument--Classic Guitar

3D Printed Musical Instrument--Classic Guitar

Electric Guitar by DarrenN2 (published at Raise3D forum)
Printer: Raise3D N2

Model from: http://www.thingiverse.com/thing:710561

Filament used was a Wood filament from Filaments.ca in Canada
Settings: 0.27mm layer height and 30% infill. Print temp of 205℃ and bed temp of 60
Total of 12 printed parts
Total print time of approximately 88 hours

The print quality is superior so it needs minimum surface finish.

Leave a comment

Please note, comments need to be approved before they are published.