ColorFabb PA-CF Low Warp - 1.75mm - 0.7 KG
Couldn't load pickup availability
Do you need help choosing the right material or 3D Printer for your application or require a quote to purchase? Contact Us
The PA-CF Low Warp is a one of a kind polyamide formulation with the ability to print nearly warp free on non heated build platforms. Low infill prints come out perfectly flat on cold bed for higher infill prints 40/50C temperature is enough to obtain flat prints.
PA-CF low warp is infused with carbon fiber for increased stiffness. Users are recommended to use wear resistant nozzles.
PA-CF Low Warp excels in tensile and impact strength and allows continues use at 120°C while retaining sufficient mechanical properties.
The formulation has been modified to reduce uptake of moisture and it also takes about 4 times longer to reach the saturation point compared to unmodified PA6. This makes PA-CF Low Warp less affected by moisture then most other nylon filaments available in the market.
CARBON FIBER IS ABRASIVE
A special point of attention is the abrasive nature of the carbon fibers. In general these fibers will accelerate the nozzle-wear of brass nozzles, much faster than unfilled filaments. ColorFabb recommends to using wear resistant nozzles.
Read more about print settings and advice on https://pa.colorfabb.com
![]() |
NET WEIGHT: 0.7 KG (1.54 LB) |
|
Notes: |
260°C - 280°C |
Adviced 3d print speed: Advised Heated bed (if you have one, not strictly necessary): Advised layerheight Cooling fan |