Standard PETG Filament - Print Settings

Standard PETG Filament - Print Settings: 220°C - 260°C (start at 240°C)
  • Start at 240°C and adjust in 5°C steps within 220°C - 260°C until ideal print quality is achieved.
  • Set your print bed temperature to approximately 75-85°C (hotter for the first few layers if possible). If further bed adhesion is required, keep increasing the bed temp by 5°C until it improves.
  • PETG doesn’t need to be squeezed onto your heated bed, you want to leave a slightly larger gap on the Z axis to allow more room for the plastic to lay down. If the extruder nozzle is too close to the bed, or previous layer it will skim and create stringing and build-up around your nozzle. We recommend starting off moving your nozzle away from the bed in 0.02mm increments, until there is no skimming when printing.
  • Print on textured PEI, or use a thin layer of glue stick as a release agent on smooth PEI or glass (PETG can bond too well to bare smooth PEI).
  • Best practice before printing any PETG material is to dry it before using (even if new), dry at 65°C for at least 4 hours. If possible, dry for 6-12 hours. Dried PETG should last for about 1-2 weeks before needing to redry.
  • If print is too stringy, also try under-extruding a bit. PETG can be sensitive to over extrusion (blobbing etc.) – if you’re experiencing this, just bring in the extrusion setting on the slicer ever-so-slightly each time until it stops.
  • Part cooling fan 30-50%.
  • No raft. (if the print bed is not heated, consider using brim instead, 5 or more mm wide.)
  • 60-100mm/s print speed (150-200mm/s on high-speed printers). Full settings in our temperature guide.